Maybe Baby

Maybe Baby Easy Ovulation Tester


How to use the Maybe Baby® Easy Ovulation Tester

Please ensure that you have not eaten or drunk anything for at least 3 hours before using the Maybe Baby Easy Ovulation Tester as the saliva sample needs to be free of contaminants. Food, drinks, toothpaste, mouthwash, chewing gum and smoking will interfere with the results. Drinking water will not affect the results.

We recommend that you take the sample first thing in the morning, before eating or brushing your teeth.

1. Remove the protective cover (Fig. 1).

 

2. Remove the viewfinder by gently pulling it straight out of the housing (Fig. 2).

Do not unscrew the rotating eye piece from the viewfinder.

 

3. Clean the sample plate with the lint-free cloth provided (Fig. 3).

NEVER apply water directly to the sample plate or viewfinder.

 

4. With a clean dry fingertip, place a drop of saliva onto the sample plate and spread a layer ensuring that you cover the entire surface (Fig. 4).

Gently glide any bubbles to the side of the sample plate onto the black area.

Saliva from underneath your tongue should contain the least amount of bubbles.

 

5. Allow the saliva sample to air dry - only dried saliva will produce patterns.

Patterns are not viewable when wet. This should take approximately 10-15 minutes.

Do not use any heated appliances to reduce drying time as this may affect the patterns formed. View your results soon after the saliva sample has dried as prolonged exposure to air may interfere with the results.

 

6. After the saliva sample has dried, reinsert the viewfinder into the housing cylinder (Fig. 5).

 

7. Hold the Maybe Baby Easy Ovulation Tester up very close to your eye and press the light switch on the bottom. Rotate the viewfinder to focus the image until a clear pattern is seen (Fig. 6).

 

8. Compare the image to the ones shown in this leaflet and record the results on the Fertility Cycle Chart provided.

 

9. Clean the dried saliva from the sample plate with the lint-free cloth. If the dried saliva is hard to remove, moisten the cloth only with a small drop of water.

 

10. Replace the protective cover.

Maybe Baby® Ovulation Tester Parts

1 Protective Cover2 Viewfinder

2.1 Eyepiece (rotating part of the viewfinder through which you look to view results)

2.2 Saliva Sample Plate (flat clear surface of the viewfinder)

3 Housing Cylinder

4 Light Housing

4.1 Light Switch

4.2 Batteries

4.3 Light Globe

4.4 Protective strip around batteries (may vary in colour)

 

 

You are leaving www.maybebaby.com.au

This link is provided for your convenience. Please note that this third-party website is not controlled by Care Pharmaceuticals or subject to our Privacy Policy.
Care Pharmaceuticals takes no responsibility for the content of these external sites, nor does Care Pharmaceuticals endorse, warrant or guarantee the products, services or information described or offered at these external Internet sites.
Thank you for visiting our site. We hope your visit was informative and enjoyable.

Cancel Continue

Maybe Baby® Easy Ovulation Tester